
Roof Replacement in Richfield MN | How To Replace Roof Shingles
Shingles are one of the most common elements found on a roof. They serve as an important barrier between your home and the outside environment. They also look great when properly installed! Over time, however, shingles can wear down or become damaged. When this happens, you must replace them as soon as possible so that water infiltration won’t further damage your house. In this article, we will discuss how to replace your roof shingles: Roof Replacement in Richfield MN
1. Remove the Damaged Shingle
With the damaged shingle removed, it’s time to install the new one. Here are a few tips for this step:
- Use a hammer and pry bar or nail puller to remove any nails that remain in the sheathing of your roofing structure.
- When replacing shingles with tabs at their ends, place them directly over their corresponding mortises in the sheathing of your roofing structure so that they rest flat against it without hanging down too far or being too tight against each other when installed.
- If you don’t have enough shingles left over from your previous project to cover up any gaps caused by removing damaged ones, purchase some extra ones now so that they’re ready once you’ve finished installing all of yours!
2. Apply Roofing Cement Under the Shingle Tabs
- Apply roofing cement under the shingle tabs.
- Place a small amount of roofing cement on the bottom of each tab and press it firmly into place, ensuring they are not overlapping.
3. Slide a New Shingle in Place
Slide the new shingle into place. Make sure it is the right way up, seated properly, and level. If it’s upside down, it could rip off when you go to nail it in place.
4. Nail the Shingle In Place
Once the shingle is in place, you can nail it down. A roofing hammer is the best tool for driving nails into a shingle. If you don’t have one, you can use a nail set and a hammer instead. You’ll also need to have galvanized roofing nails on hand (or other hardware if you require different materials).
If you’re using an air nailer, that’s all there is to it! However, if you’re using a pneumatic or cordless nail gun instead of an air compressor, then here are some tips:
- Your gun should be set so that when the trigger is pulled, only one nail will come out at once. If this isn’t done correctly then there could be issues with jamming or misfires when firing off multiple nails.
- Ensure the safety mechanism works properly before loading your gun with shingles.
After the nails are in place, apply more roofing cement over each one.
Replacing shingles on your roof is an excellent way to ensure the structure stays in good shape. It’s also a great way to save money and keep your house looking nice from the outside. If you’re planning on doing this project yourself, be sure to use safety gear like gloves and goggles to protect yourself from cuts or other injuries and work boots for traction on slippery surfaces!
If you have more questions or want to leave replacement up to the professionals, contact your local contractor today. We are Capstone Bros. Contracting, a contracting company based out of Richfield, Minnesota, and we are always happy to assist you!